<VV> Re: CARB BLOCK OFF PLATES

[Roger Gault]

If you leave the carbs in place and just sandwich the block-offs between the
insulator and the bottom gasket, metal from your favorite beverage can (Dr.
Pepper in my case) works fine.  Cuts with scissors.  ;-)

Roger   (ran that way for years)

----- Original Message ----- 
From: <N2VZD at aol.com>
To: <virtualvairs at corvair.org>
Sent: Saturday, August 11, 2007 8:40 PM
Subject: <VV> Re: CARB BLOCK OFF PLATES


> i cut some out of 1/2 inch aluminum so they wont warp.  thinner  ones dont
> seem to stay sealed for long.
> my next step is 95hp heads and sell all my 140 stuff...when i get  time.
i
> am not happy with them on powerglides.
> regards, tim colson
>
>
>
> ************************************** Get a sneak peek of the all-new AOL
at
> http://discover.aol.com/memed/aolcom30tour
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________