<VV> PG modulator valve

[Ron]

I looked at swap meets and found a couple of stamped 1" wrenches which I 
keep in mt tool bags.
RonH

----- Original Message ----- 
From: "Frank DuVal" <corvairduval at cox.net>
To: "Frank Maloof" <corvette at velocity.net>
Cc: <virtualvairs at corvair.org>
Sent: Saturday, August 04, 2007 5:10 PM
Subject: Re: <VV> PG modulator valve


> It has wrench flats that a 1" very thin wrench will fit. Buy the cheapest 
> 1" combination wrench you can find and grind it thin to fit. Waay back you 
> could buy thin cheap wrenches at five and dime stores...
>
> I'm sure for $$$ Snap-On will sell you the proper tool! :-)
>
> Frank DuVal
>
> Frank Maloof wrote:
>
>>i see that i am leeking a little from the modulator valve , in the book i 
>>see there is a gasket under it , how do you take it off , do you have to 
>>have a tool or what , Thanks Frank From Near Erie Pa
>> _______________________________________________
>>This message was sent by the VirtualVairs mailing list, all copyrights are 
>>the property
>>of the writer, please attribute properly. For help, 
>>mailto:vv-help at corvair.org
>>This list sponsored by the Corvair Society of America, 
>>http://www.corvair.org/
>>Post messages to: VirtualVairs at corvair.org
>>Change your options: 
>>http://www.vv.corvair.org/mailman/options/virtualvairs 
>>_______________________________________________
>>
>>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>