<VV> brake MC Rebuild

[Frank DuVal]

Make sure you remove the rubber seal from the end of the cylinder. That 
is the end waayy down inside. Not all cylinders have the seal set up 
this way, but if it does it needs to come out so the new parts fit right.

I like to bench bleed the master (should be instructions in the kit...) 
But others here never do it, just bleed the system as per shop manual 
and the master will be bled.

 I also would suggest silicone fluid since you are doing a whole 
rebuild. But others here will warn of impending doom. I have used 
silicone in MANY systems since 1980, some of which are still holding 
fluid to this day with no further work.

Frank DuVal

Bill Brafford wrote:

>i am in the process of rebuilding the brakes on my 63 spyder, included in the brake kit is rebuild parts for the master cylinder. Never done this, anything that others have experienced that i should know about or is it pretty staright foreword?
>
>Bill
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>
>  
>