<VV> Push rods

[Bryan Blackwell]

That makes sense, however if you are replacing - or have replaced - any 
of the other valve train parts, I'd go ahead and check the geometry 
rather than assuming .070 is correct.

--Bryan

On Nov 22, 2006, at 9:02 AM, <phil.wiley at insightbb.com> wrote:

> I have a question. If you have .070 removed from the gasket surface on 
> a set of 140 heads and the rest of the valve train is stock do I need 
> to order push rods that are .070 shorter to keep rocker arm geometry 
> correct?
> Thank in advance.