<VV> engine hoist Woes

[timogensturbo at aol.com]

-----Original Message-----
Just unloaded an engine with my hydraulic engine hoist. Boom would not go up all the way. Checked fluid level and bleed the cylinder, still only lifts about 1/3 full height. Left the engine hang for 10 minutes and it doesn't drop. But still lifts to a point and will not lift any farther, just kind of bounces up an 1/8" and then goes back down to where it was. Any ideas? Bob 
===============================================
 
Remove engine [load],  raise boom to highest point.....open bleeder...add fluid as required
 
Matt Nall
________________________________________________________________________
Check out the new AOL.  Most comprehensive set of free safety and security tools, free access to millions of high-quality videos from across the web, free AOL Mail and more.