<VV> splitting the block over a tooth

[Harry Yarnell]

Uh, sounds like an assembly issue, not 'expert' advice.

Harry Yarnell
Perryman Garage and Orphanage
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "4carbcorvair" <4carbcorvair at gmail.com>
To: <virtualvairs at corvair.org>; <djtcz at comcast.net>
Sent: Sunday, May 28, 2006 2:14 PM
Subject: <VV> splitting the block over a tooth


I had a few 'experts' on a certain Corvair forum tell me that I was going
overboard wanting to change the cam in my 140 when I was planing my rebuild.
So I took the advise of the experts. About 100 or so miles on it after the
rebuild and I get to tear the engine apart again, to replace the cam,
lifters, main bearings, rod bearings, anything else I find messed up and
flush the HUGE amount of metal that is throughout my engine. It's only money
and time.....