<VV> Pertronix Ignitor

[Bill Elliott]

Unlike the Ignitor I, the Ignitor II is designed to run on ballasted 
voltage (though it's happier on 12v), but you're spot on with the timing 
change... mine moved about 15 degrees as well.

Bill

Clark Hartzel wrote:

>Message: 10
>Date: Wed, 19 Jul 2006 18:32:19 -0400
>From: Paul Abel <pbob63 at frontiernet.net>
>Subject: <VV> ignitor2 question
>I just installed ignitor 2. I followed the directions. Car starts, but
>won't stay running. Why? I'm using the stock coil until flamethrower
>arrives. Was I correct to leave the existing wire to the + terminal of
>the coil?
>-Paul-
>
>Did you hook up the red wire to 12 volts?  Need to run a new wire bypassing
>the resistor wire.
>Did you check the timing?  Mine needed about 15 degrees more advance to get
>to 12 degree mark.
>Don't know why the Ignitor changes timing so much but it does!
>Clark Hartzel
>
> __
>  
>


-- 
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.10.1/391 - Release Date: 7/18/2006