<VV> Removal of Corsa C Emblem

[Marc Marcoulides]

You might get lucky and they are attached with barrel faseners. If they are, put masking tape on the panel and wedge one side of a screw driver on the (masked) panel and other under the emblem, then twist.

-----Original Message-----
>From: bmooers at farniente.com
>Sent: Jul 7, 2006 11:48 AM
>To: virtualvairs at corvair.org
>Subject: <VV> Removal of Corsa C Emblem
>
>I am having trouble removing the Corsa C emblems from the rear panels of 
>my 66 Corsa Conv. I have taped around them so that I do not scratch the 
>paint, I have also sprayed them with WD40 to loosen and corrosion etc - 
>but they are stuck on there! Tried pulling on them with vice grips and 
>pliers.....Any ideas of how to get them loosened would be helpful - a 
>simple project  - but boy - they wont budge!
>
>I do not think they have ever been off of the car. It is an early 66 - 
>those should be held in with push pins correct??
>___________________________
>Bruce C. Mooers
>
>66 Corsa Conv
>63 Spyder Conv
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________