<VV> hosed

[J R Read_HML]

It would help to use a clamp with a hex head and a short 1/4 inch drive 
ratchet.  Hard to put a screw driver into a slot you can't really see.

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: <AeroNed at aol.com>
To: <virtualvairs at corvair.org>
Sent: Sunday, January 15, 2006 11:26 PM
Subject: Re: <VV> hosed


>I don't think this is in the FM...
>
> I've installed the hose from the driver's side reaching up and over  the
> differential. Sure it's blind but all you have to do is get the hose 
> installed
> and tighten the clamp. Not the easiest thing to do but you don't need  any 
> extra
> jointed limbs either.
>
> Hope that helps,
> Ned
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________