<VV> Pressure Plates

[BobHelt at aol.com]

In a message dated 1/3/2006 1:25:35 PM US Mountain Standard Time,  
PIROCZ at aol.com writes:

I have a  good 140 HP Pressure plate that I know is in good condition. I want 
to  replace one that is worn. Do I need to have the flywheel and this 
Pressure  
plate balanced? It is going in a street  car.




I'd say that it all depends. If you are matching unmolested factory  original 
parts, then no. But if thre is any doubt, then I'd suggest that you get  them 
balanced. Of course you know that the flywheel and PP will have the  greatest 
amount of rotating inertia, so that any imbalance can cause a  vibration. So 
to be on the safe side, I'd recommend a balance.
Regards,
Bob Helt