[Fwd: Re: <VV> front lower ball joints]

[Jim Burkhard]

Seth sent me this off list.  It's been so long that I did 
the job, I forgot that the lower ball-joints are only 
pressed in. Only the uppers need rivet drilling. I found 
that the pressout tool (bought years ago from Clarks I 
think) worked well.

Jim

-------- Original Message --------
Subject: 	Re: front lower ball joints
Date: 	Sun, 01 Jan 2006 01:06:45 -0500 (EST)
From: 	Sethracer at aol.com
To: 	burkhard at rochester.rr.com

Bottoms are only pressed in ( some real early ones were 
threaded in from the bottom) - Only the uppers are riveted - 
replacements are bolted-in on uppers. Lowers are just 
pressed. Not sure if that was clear in your
note. -Seth