<VV> bell lhousing
BBRT
chsadek at adelphia.net
Thu Dec 28 22:53:27 EST 2006
Measure depths of holes. Most are about an inch and a quarter I think.
Longer ones go where they can-check the depth. Don't use washers on the
holes that have bosses on them, that brings them closer to the flywheel,
those nearer the bottom, and might hit the flywheel. 3 or 4?
----- Original Message -----
From: "Bob Gilbert" <traceya at montrose.net>
To: "Virtual Vairs (E-mail)" <virtualvairs at corvair.org>
Sent: Thursday, December 28, 2006 7:53 PM
Subject: <VV> bell lhousing
> Howdy Folks,
> I am working on a basket case where a mechanic used whatever nuts and
> bolts he could find. All of the bell housing to block bolts have washers
> and some bolts are after market ones. Where can I find out the proper
> length and which bolts have a washer on them?
> Thanks,
> Bob
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
More information about the VirtualVairs
mailing list