<VV> "Spring clip" on left front hub

[Sethracer at aol.com]

In a message dated 12/27/2006 9:09:32 AM Pacific Standard Time,  
hyarnell1 at earthlink.net writes:

If it's  the right clip, it should have three legs; the outside one's curved 
to fit  the groove in the spindle nut, and a shorter center pin to go in the  
spindle hole. It just finger presses on.

harry  yarnell



However, it requires the correct nut on the spindle. It is not the standard  
"Castle" nut with the "parapets- SP?" to allow the cotter pin to go through. 
The  correct nut for the left side has a groove/slot cut into/around in the 
middle of  the nut to allow that pin to snap over and lock the nut, while 
allowing the  speedometer drive cable to pass through the spindle. If the nut you are 
using  looks just like the one on the right side, (i.e. no groove/slot) you 
need to go  find the correct nut. - Seth Emerson