<VV> Re: VV - End Casting

[Roger Gault]

And a very merry Christmas to you, too.

Nuts, Distributor, Harmonic Balancer.
Bigger hammer (and a block of wood).

Cheers,
  Roger G.

----- Original Message ----- 
From: "Robert Paul" <barnaby at shaw.ca>
To: <virtualvairs at corvair.org>
Sent: Tuesday, December 19, 2006 6:13 PM
Subject: <VV> Re: VV - End Casting


> Hi One and all,  First may I say Merry Christmas and a Happy New year to
everyone on VV and their families. Secondly, to remove the end casting from
the block, do I need to remove the distrubutor?  I think I have all of the
bolts rmoved but the casting is on tight, I did not try to hit it with a
bigger hammer, and I put my shop manual in a safe place last time I used
it....so safe I can't find it.  Any help on this one?
> Thanks again
> All the best
> Robert Paul
> 66 Monza Convt
> 65 Corsa 4spd
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________