<VV> Re: - End Casting

[BBRT]

You must remove the distributor.  The lower end is like a thick flat/slotted 
screwdriver which fits in the oil pump, located in the rear housing.  You 
should be able to easily tap and remove the rear housing.

Good Luck

Chuck S
----- Original Message ----- 
From: "Robert Paul" <barnaby at shaw.ca>
. Secondly, to remove the end casting from the block, do I need to remove 
the distrubutor?  I think I have all of the bolts rmoved but the casting is 
on tight, I did not try to hit it with a bigger hammer, .  Any help on this 
one?
> Thanks again