<VV> fuel pressure

[Zane Brock]

What you see as strapping is actually heavy flat stock not the stuff that
comes in a roll. She's bolted through with large washers with over a third
of the tank snuggly inside the boxed out area. It is right and tight.

 

Regards,

 

Zane Brock

zanebrock at bellsouth.net

678-494-5281office

678-231-6373 cell

  _____  

From: Sethracer at aol.com [mailto:Sethracer at aol.com] 
Sent: Tuesday, December 19, 2006 2:35 AM
To: zanebrock at bellsouth.net
Subject: Re: <VV> fuel pressure

 

In a message dated 12/18/2006 5:14:00 PM Pacific Standard Time,
zanebrock at bellsouth.net writes:

The wood is temp till I can find/fab a better support. The odd shot is of
the boxed out area under the car. My advise is to go with a smaller tank,
this one is a 17 gal and to position it in the stock position. Then you
could plumb it with the original filler pipe. Summit Racing does have this
version.

 

Regards,

 

Zane Brock

zanebrock at bellsouth.net

678-494-5281office

678-231-6373 cell

Thanks, Zane. I already have a 12 gallon FuelSafe Enduro Cell on it's way.
It is SCCA legal and comes in a sheet metal can. The same cell is mounted in
Rick Norris' car. See attached photo. I am tring to tuck it as far back as
possible, to allow an oil cooler air outlet to drop down before reaching it.
Are you satisfied with the retention of your tank in place? It doesn't seem
particularly secure. - Seth