<VV> Help with 110hp engine disassembly--torque convertor

[TimogensTurbo at aol.com]

In a message dated 12/18/2006 6:15:34 PM Pacific Standard Time, 
matthew_lockwood at hotmail.com writes:

> The entire flywheel and convertor 
> assembly can be wiggled, but it doesnt appear to be sliding out.  What am I 
> missing here?
> 
================================================


Normally the 3 BOLTS holding the TQ to the Flerxplate [ flywheel] are removed 
and the TQ slid INTO the Diff.....  separating the TQ from the 
crankshaft.....all it is is a large pin that slips into the pilot hole in the crank.....get 
the 3 bolts out and start wiggling!


Matt Nall