<VV> LM Gas Tank Removal

[ChiefTAM at aol.com]

As I drained the old gas out of the tank in my 69 prior to starting the  
newly rebuilt engine, I noticed there was some rust inside (as looking into the  
sending unit hole) and have decided to remove it and have it cleaned before I 
do  to much running of the new motor.  I have looked at the shop manual, body  
service, assembly manual and the Basics guide for instructions, but still  
have a few questions I could use a little assistance on.
 
1.  In removing the stabilizer bar, I can see you have to take it off  each 
end, but the two inner mounts can be removed either at the bar or where the  
mount attaches above the bar to the body.  Which is better/easier to remove  and 
reinstall?
 
2.  Can all hoses be detached/reattached from underneath?
 
3.  Will the tank drop down without removing or loosening the front  
crossmember?
 
4.  Any known problems/issues reinstalling?
 
5.  Any hints for a person doing a first time tank removal?
 
By the way, I do have a four post lift to get the car in the air, so that  is 
not a problem.  Thanks for the help.
 
Todd "rusted inside in Texas"