<VV> starting after sitting..follow up.
BobHelt at aol.com
BobHelt at aol.com
Tue Aug 1 17:01:53 EDT 2006
In a message dated 8/1/2006 1:44:34 PM US Mountain Standard Time,
pbob63 at frontiernet.net writes:
. My question is, can I take the bent tube and
rod out, and using the old rod, try to force the lifter loose by
hammering on it without removing anything else, then install another rod
and tube? I did this on one on the left side, and it is one of the ones
that is functioning now.
Paul,
Strange things happen, but I fail to see how a stuck lifter would bend a
pushrod. I would think that a stuck valve (in the guide) is much more likely to
be at fault.
Regards,
Bob Helt
More information about the VirtualVairs
mailing list