<VV> Grey distributer cap

[J R Read_HML]

I don't know the cap you refer to, but how does the OD on the plug holes 
compare to the "normal" one?  Perhaps it is a little too large for the boots 
to stay in place?

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: "Padgett" <pp2 at 6007.us>
To: <virtualvairs at corvair.org>
Sent: Saturday, April 22, 2006 1:44 PM
Subject: Re: <VV> Grey distributer cap


> Cap is apparently from Clarks and has a "made in Mexico" (in English) 
> sticker.
>
> Question is how do you keep the plug and coil wires on ? Car has an Orange 
> set of 8mm plug wires (also apparently from Clarks - both installed by PO) 
> and every time I stop they need to be seated all the way again. What is 
> going on ?
>
> Padgett
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________