<VV> 63 Spyder Wiring
BobHelt at aol.com
BobHelt at aol.com
Tue Apr 18 17:05:11 EDT 2006
In a message dated 4/18/2006 10:42:57 AM US Mountain Standard Time,
stalder at cox.net writes:
I have my engine wired up now with an ignitor I. I hooked the black wire to
the neg side coil and the red to the harness side of the resistor. The rest
of the wiring is done per the diagram in Bob's book. I can't start it yet
because I have not installed a gas tank. But when I have the ignition on to
work on other electrical issues I sometimes get smoke form the resistor. Not
always though. I turn everything off as soon as notice smoke. Does anyone
now why this happens?
Hi,
I'm confused. This is a Spyder with an external and separate resistor, right?
If so, now you should have only one wire going from the resistor to the +
side of the coil. Check that there aren't other wires connected to that terminal
on the resistor (or coil). The resistor block is only a dropping resistor
between the +12v from the ign switch and the coil. It serves the same function
as the resistance wire on the other Corvairs. If there is only one wire on
that resistor terminal,disconnect it and see if you get the smoke. But I'll bet
there is something else connected there besides the coil. PS the tach
connects to the - side of the coil.
Let us know the results.
Regards,
Bob Helt
More information about the VirtualVairs
mailing list