<VV> Emblem holes

[Shaun]

0.250" to 0.253" (1/4")
I knew I'd seen it somewhere, in the 'options' section of the assembly
manual.

yea, Vairily ... Shaun

----- Original Message ----- 
From: "Ron" <ronh at owt.com>
To: <virtualvairs at corvair.org>
Sent: Monday, September 26, 2005 6:48 PM
Subject: <VV> Emblem holes


What size drill is used for the holes for push in emblems?

RonH
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________