<VV> Head Torque

[kaczmarek at charter.net]

Guys

More likely than not, the tool that Craig has was stocked in the tool room for rework.

Hank
> 
> From: Sethracer at aol.com
> Date: 2005/09/12 Mon PM 01:38:17 EST
> To: NicolCS at aol.com,  virtualvairs at corvair.org
> Subject: Re: <VV> Head Torque
> 
>  
> In a message dated 9/12/2005 11:08:58 AM Pacific Daylight Time,  
> NicolCS at aol.com writes:
> 
> Ah  So!  Good point, Batman.
> The engine ID stamping clearly indicated TO  (Tonawanda) on every Corvair 
> engine that I have ever seen and those marks  are only stamped on assembled 
> engines 
> regardless of where they were cast.  Perhaps the tool I have was used for 
> rework  only?
> Craig
> _______________________________________________
> 
> 
> Snap-On - and probably others - made the so-called collapsible socket  for 
> head stud torquing the Corvairs. I've used a couple of them, but could never  
> convince the owners to let me buy one from them. - Darn! -  Seth
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
>  _______________________________________________
>