<VV> '65 Corvair question

[Cash Case]

While I've purchased a new fly wheel and clutch pressure plate, I've  
not put the fly wheel on the end of the crank yet. I'll keep in mind  
your caution when I get there.
-Cash


On Sep 11, 2005, at 5:45 PM, NicolCS at aol.com wrote:

> I had a motor that jammed-up just like you are describing.  The PO had
> installed the MT flywheel without the large 7-hole washer.  Without  
> that  washer,
> the flywheel bolts collided with the crankshaft's cam-drive gear  
> and  bent the
> ends of the gear teeth.  I had to pull the crankshaft and have the   
> cam-drive
> gear and hub replace.  Ugh.
> Craig Nicol
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all  
> copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv- 
> help at corvair.org
> This list sponsored by the Corvair Society of America, http:// 
> www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/ 
> virtualvairs
>  _______________________________________________
>