<VV> Rebuild II

[Harry Yarnell]

Ya do them by hand. I'm assuming your talking the scrapper rings for the oil 
control ring.

Harry Yarnell
Perryman Garage and Orphanage
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "Stephen Upham" <contactsmu at sbcglobal.net>
To: <virtualvairs at corvair.org>
Sent: Monday, September 05, 2005 3:22 PM
Subject: <VV> Rebuild II


>      Just purchased a piston ring expander.  The description says it 
> installs and removes rings from 3/64 to 1/4 in.   There are the chrome 
> rings and the (what look like) gray steel rings that are 1/16 [no problem 
> there].  My concern would be with the conformatic rings and the black with 
> a chrome edge rings that measure 1/48 inch.  Will the expander work on 
> these rings, or do I need a special Corvair ring expander?
>
> Stephen Upham
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________