<VV> Fw: Damper door

[J R Read_HML]

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: "J R Read_HML" <hmlinc at sbcglobal.net>
To: "Padgett" <pp2 at 6007.us>
Sent: Tuesday, November 01, 2005 8:23 PM
Subject: Damper door


> No...  This is done with shroud removed, not air grill.  As in, installing 
> the shrouds at the end of summer!
>
> You can see in the end of the door to line up the holes on the clip and 
> door tab.  You cannot see while inserting the rod end through those holes.
>
> Attachments (if any) are scanned with anti-virus software.
>
> Later, JR
>
> ----- Original Message ----- 
> From: "Padgett" <pp2 at 6007.us>
> To: "J R Read_HML" <hmlinc at sbcglobal.net>
> Sent: Tuesday, November 01, 2005 8:17 PM
> Subject: Re: <VV> Re: VirtualVairs Digest, Vol 10, Issue 5
>
>
>>
>>>Squeeze the round part of the jesus clip tight and place it on the tab 
>>>with the holes lined up.  It should stay there.  Insert the adjuster 
>>>shaft through the lined up holes and push the long end down onto the rod 
>>>to hold it in place.  This is WAY easier to describe than to do!  You 
>>>really can't see what you are doing and must "feel" everything into 
>>>position.
>>
>> Suspect impossible without removing the rear grille. I elected not to and 
>> was left with the "attach door to shroud while off and slide whole 
>> business in" method. First one was a PITA but second went right together.
>>
>> Padgett
>