<VV> Bleeder screws

Dave Ziegler dziegler3 at comcast.net
Sun May 22 22:44:27 EDT 2005


AND, the 14 mm spark plugs.   gggggggg

Dave. ..
On May 21, 2005, at 5:54 PM, Clark Hartzel wrote:

> From: Chris C <ricorvair at cox.net>
> Subject: <VV> What size bleeder screw
> What size bleeder screw should I have gotten?
> Autozone checked it against a bolt and it came out as a metric size.
> Since I put the same metric sized bleeder in the other wheel cyl.  Did 
> I
> ruin it?
> Clarks is close, so its time to order.
>
> I don't remember the actual thread size but they are inch, not metric!
> There are no metric parts on a Corvair except the tire valves and ball
> bearings.  I do know that FC's are bigger threads than cars.
> Autozone doesn't know anything except what is in their computer!
> You might have boogered the threads up.  Only way to tell is get the
> correct parts from one of our suppliers and try it.  It is not the
> thread that seals, it is the tapered seat.
> Clark Hartzel
>
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights 
> are the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>
>
Corvair Therapy
mechanical repair
light restoration



More information about the VirtualVairs mailing list