<VV> removing s/s trim from 64 spyder convertible

[J R Read_HML]

There are 4 or 5 of the snap buttons that have screws in them.  Once those 
are off, there may or may not be some clips.  Depends if someone has been 
there before you or not.  With caution and a small flat blade screwdriver 
and/or putty knife, you can usually get those to release.  Some are likely 
rusted and may just break off.

Attachments (if any) are scanned with anti-virus software.

Later, JR

----- Original Message ----- 
From: <Yelospdr64 at aol.com>
To: <virtualvairs at corvair.org>
Sent: Friday, March 25, 2005 3:01 PM
Subject: <VV> removing s/s trim from 64 spyder convertible


> What is the best way to remove the s/s trim that holds the rear of the
> convertible top to the body? These are the trim pieces that have snap 
> fittings for
> the boot. Do you need a special tool?
> Thanks in advance,
> Alan
> 1964 spyder convertible
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________