<VV> Window vent gasket replacement

[J R Read_HML]

Kenneth...

Ignore my "tape" answer.  I had misread and thought you were talking about a 
way of holding the glass in the frame of the vent window.

Sorry about that.

I have never changed out the rubber seals that the window closes against.  I 
would imagine that there is a screw or two buried up in the groove of the 
rubber someplace.

Attachments (if any) are scanned with anti-virus software.

Later, JR
'61 Rampside Standard 4/110
'65 Monza Convertible 4/140
'66 beater Coupe - icemobile 4/140


----- Original Message ----- 
From: "Kenneth Mangold" <kmangold at bellsouth.net>
To: <virtualvairs at corvair.org>
Sent: Tuesday, March 08, 2005 3:25 PM
Subject: <VV> Window vent gasket replacement


I am new to VV and could use a little advise.  I would like to replace the 
gaskets on the front door window vent on my '65 Monza convertible.  Could 
someone explain how.  I was hoping for instructions that came with the 
gaskets, but no such luck.  My chassis manual, and other books that I have 
don't mention replacement.

I tried to go to the archieves, thinking that articles would have been 
written, but was not able to open the webpage.

Ken Mangold
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________