<VV> Turbo housing clamp & heat shield
Jim Simpson
simpsonj@bellatlantic.net
Sun, 09 Jan 2005 16:36:55 -0500
My turbo has had the clamp rotated back so the bolt clears the rear heat
shield mounting tab since it was new. No problem whatsoever in loosing the
bolt enough to move the clamp so the bolt will clear. Just back it off a
bit until you can slide the clamp backwards and then retighten it. I
believe the shop manual gives a torque for tightening the clamping bolt --
it's not all that tight.
Jim Simpson, Group Corvair, '66 Corsa turbo