<VV> Underdash lights in a Greenbrier

[NicolCS@aol.com]

I did this job recently, and I wasn't able to find the dimple either. I did 
it well on the second side!  Really!  Following the instructions as much as 
possible, I drilled and installed the left side switch, only to find myself on 
the wrong side of a horizontal metal piece inside the door pillar.  I had to 
play some games to get the wire up into the underdash area.  On the second side, 
I knew to get above the metal divider and the wire came right into the dash 
area. Other than that, it was a snap and a really nice addition to the rig.  I 
too use an NOS kit. Very cool. 
Craig Nicol
<snip>
I have just acquired a Greenbriar that needs very little to make it  
roadworthy. In my parts stash, I have an NOS set of Courtesy Lights that I 
wish  to 
install. Not so much for looks, but the overhead dome light does leave a  lot 
to 
be desired if you're climbing inside.
  The instruction sheet says there should be a "dimple" to indicate  where to 
drill holes for the door jamb switches. I can't find them on either  side. 
<unsnip>