<VV> Arghhhhhhh.... How hard can it be to remove the outer rear tail lights on a 64???

[Shaun]

HeyJoe, don't cut the wires. Open the engine compartment lid and unplug the
harness there. The left side has a round plug that you pull off then push
the round grommet/plug down through the body.  The right side has a square
plug and a little prong that goes into a hole in the body. You'll see, it
becomes obvious when you get there.

yea, Vairily ... Shaun

----- Original Message ----- 
From: "Joe West" <joew@diveaz.com>
To: "VV" <virtualvairs@corvair.org>
Sent: Saturday, January 01, 2005 3:18 PM
Subject: <VV> Arghhhhhhh.... How hard can it be to remove the outer rear
tail lights on a 64???


> Sheesh.
>
> I'm taking all the trim off and I get to the rear tail lights on my 64 and
I
> can't seem to figure out how to get the light housings out.  More
> specifically, I can't seem to figure out how to disconnect the harness.  I
> pulled back the harness boot and the wires go directly into the aluminum
> housing and I can't see any way to disconnect them short of cutting the
> wires.
>
> Help???
>
> :D
>
> Thanks Everyone!
> (and yes, I have the factory service manual and no... I can't find where
it
> tells how to disconnect the outer tail lights).
>
> Joe
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
>  _______________________________________________