<VV> What to do first?

[Dave Ziegler]

POR-15 doesn't stick to new shiny metal. I'd roughen it up first.
Dave.. .
On Feb 24, 2005, at 5:44 AM, airvair wrote:

> I'd use POR15, then the seam sealer as needed. I haven't found 
> Rustolem to be very long lasting. Be sure to coat both sides of the 
> floor panels, as you are likely to get moisture on both the bottom of 
> the car as well as inside thru the carpet.
>
> -Mark C
>
> Ron wrote:
>
>> I am installing some new floor panels and am wondering what the order 
>> should be between applying a rust proofing paint and seam sealer.  
>> Should I paint the panels and weld bead with Rustoleum (or an 
>> equivalent) first and then apply the seam sealer or seam seal first 
>> and then paint?  Any advice will be appreciated.
>>
>> RonH
>>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights 
> are the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>
>
Corvair Therapy
mechanical repair
light restoration