<VV> Rebuild II

[BobHelt at aol.com]

In a message dated 12/19/2005 2:00:53 PM US Mountain Standard Time,  
contactsmu at sbcglobal.net writes:

In the  service manual, it states;
" ... install distributor as  follows: Rotate crankshaft 
counterclockwise until number 1 cylinder is a  T.D.C. (timing mark to 0 
on tab) of COMPRESSION stroke (fig. 76)  [  and you can tell if it is 
the COMPRESSION stroke by ....?]
Set distributor with rotor pointing to number on cylinder position and  
note position of drive tang on distributor shaft.
Using a  long screw drive, turn oil pump shaft [did they say take the 
distributor  out first, NO] 


Hate to tell you bro, but they never told you to install the distributor  yet 
in that procedure..............
Regards,
Bob Helt