<VV> 140 Fuel lines with Electric pump

[Marc Marcoulides]

There is a Freezeplug that fits

-----Original Message-----
From: Larry Forman <larry@forman.net>
Sent: Sep 2, 2004 2:36 PM
To: Anil Mittal <anil@anil.com>, virtualvairs@corvair.org
Subject: Re: <VV> 140 Fuel lines with Electric pump

Anil,
You loosen all the lines at each carb and at the "T" connector going to the stock fuel pump.  Then rotate all the lines 180 degrees so the input goes in from the front of the engine.  Plumb into that location.  Then remove the stock pump push rod and possibly replace the stock pump with a plug.  Larry Claypool has these and likely others do too.

-- Larry
----- Original Message -----
From: "Anil Mittal" <anil@anil.com>
Date: Thu, 2 Sep 2004 15:51:43 -0400
To: virtualvairs@corvair.org
Subject: <VV> 140 Fuel lines with Electric pump

> Hello All,
> 
>    How does one "redo" the 140 fuel lines when running an electic
> fuel pump? Thank you.
> 
> Anil
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs 
> _______________________________________________
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help@corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs@corvair.org
List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs 
_______________________________________________