<VV> [FC] clutch head screws

[N. Joseph Potts]

I don't know the size of the clutch head driver, but if you buy one of those
sets of 50 or so bits (Torx, hex, square, Phillips, slot, and so on), you'll
get several sizes, of which one will be the correct one. In fact, you may
already have such a set, in which case, look there.
     If I wanted new screws, I'd check www.mscdirect.com, but I wouldn't be
too sure of finding what you need. I think you could get a (dedicated)
screwdriver for clutch heads there, if you really prefer to go that route
(over the bits).

Joe Potts
Miami, Florida USA
1966 Corsa coupe 140hp 4-speed with A/C

-----Original Message-----
From: virtualvairs-admin@corvair.org
[mailto:virtualvairs-admin@corvair.org]On Behalf Of Keith Hammett
Sent: Tuesday, May 25, 2004 11:33 AM
To: virtualvairs@corvair.org
Subject: <VV> [FC] clutch head screws


I know this has been asked before but I didn't pay any attention then.  What
size is the driver for the clutch head screws that hold the engine and
transmission cover in place?  Where can you buy it?  and are new bolts
available with the same head?

This is for a Rampside.

Keith Hammett