<VV> 2 questions on LM 110 engine (stuck engine???)

[J R Read_HML]

You should be able to turn the engine - either direction by using two hands
on the belt - one on each side.  This assumes that the balancer is in place!
Be careful of pinching you hand in a pulley.


Attachments are scanned with anti-virus software.

Later, JR
'61 Rampside Standard 4/110
'65 Monza Convertible 4/140
'66 beater Coupe - icemobile 4/140

----- Original Message ----- 
From: <JVHRoberts@aol.com>
To: <roharvey@nestor.nmsu.edu>; <virtualvairs@corvair.org>
Sent: Thursday, May 20, 2004 4:16 PM
Subject: Re: <VV> 2 questions on LM 110 engine (stuck engine???)


> For #1, the engine turns CCW looking at the harmonic balancer.
> For #2, it's a 3/4 inch socket. Unfortunately, turning the engine the
normal
> direction with a wrench will often loosen the bolt.
>
>
> In a message dated 5/19/2004 11:57:45 PM Eastern Standard Time,
> roharvey@nestor.nmsu.edu writes:
>   1. Which way(direction) does the engine harmonic pulley turn ?
>   2. what size socket fits this pulley (to turn engine,in regards to
> Question #1)
> thanks for the help
> bob
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________