<VV> Powerglide again

[VairMech@aol.com]

In a message dated 3/2/2004 6:59:45 AM Eastern Standard Time, 
hyarnell1@earthlink.net writes:
There's no need for a torque wrench to adjust the low band. Back off (or
remove) the locknut, mark one flat on the adjusting screw with pencil or
Magic Marker (as a reference), and tighten the screw. You want to make the
'tightening' point to be 'snug'; don't honk on it. Then back the screw out 4
turns. Reinstall the locknut, and you're done.
>>>>>>>>>>>>>>>
    I agree, Finger tight is almost 20 inch pounds on the center adjuster.
    Ken Hand