<VV> Fuel pump noise

[Eric S. Eberhard]

No flame taken.  Read instructions?!  I thought instructions were for 
people too stupid to figure it out themselves :-)


At 10:17 AM 6/8/2004, VairMech@aol.com wrote:
>In a message dated 6/8/2004 1:02:02 PM Eastern Standard Time,
>flash@vicspdi.com writes:
>
>I bought  a new pump at Napa ... it leaked right out of the box.  I
>tightened  the screws on top and it works fine.  You might try  that.
>
>
> >>>>>>>>>>>>
>     If you read the instructions in the box they tell  you that the pump is
>shipped loose and to tighten the top cover screws to  prevent leakage.
>     No Flame Intended.
>     Ken Hand
>_______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are 
>the property
>of the writer, please attribute properly. For help, mailto:vv-help@corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs@corvair.org
>List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
>_______________________________________________

Eric S. Eberhard
(928) 567-3727          Voice
(928) 567-6122          Fax
(800) 569-1122          Denver Office (I am never there, you can leave a 
message)
(720) 339-4765          Cell

http://www.vicspdi.com

Completely updated web site of personal pictures with many new 
pictures!  Includes horses, dogs, Corvairs, and more.

http://www.vicspdi.com/ourpics/index.html