<VV> pertronix ll ?
BobHelt@aol.com
BobHelt@aol.com
Sat, 10 Jul 2004 15:11:06 EDT
In a message dated 7/10/04 10:32:56 AM Pacific Daylight Time,
s10birdman1966@yahoo.com writes:
<< is it OK to run 12 volt ign to stock coil,instead of resistor wire in
harness ? >>
Pertronix II was designed to use their 0.6 ohm pri coil. Why don't you use
it? Then +12 volts is OK. But with a stock coil, +12 will probably stress the
stock coil too much and overheat it. I'd suggest that you keep the ballast res
in the circuit.
Regards,
Bob Helt