<VV> Re: accelerator pump cups

[Dave Ziegler]

Ron, one little trick I use is to cut the tapered plastic tip off of a 
tube of caulk, sealer etc. When trimmed to the correct diameter and 
placed on the end of the pump rod and moistened, the new cups slide 
right on.
Dave.. .
On Dec 23, 2004, at 2:40 PM, ronchoy@comcast.net wrote:

> Is there an easy way to install replacement cups onto accelerator 
> pumps? I've tried and failed. Either my tools are too simple, or my 
> mind is.  Any ideas?
>   BTW, I just replaced pumps on my '65. One side not pumping at all, 
> the other side barely. Funny thing is the only symptom was a reluctant 
> first start.   -ron 65,66
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights 
> are the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
>  _______________________________________________
>
>
Corvair Therapy
mechanical repair
light restoration