<VV> Installing viton o-rings

[Duane, Jim]

Hi Guus.

No need!  The head doesn't have to budge.

Just remove the studs holding the tube into the block (one retainer at a
time).  Then re-torque and move down the line.

Jim Duane
'66 180 Corsa cvt.
Colonial Corvairs
CORSA


-----Original Message-----
From: virtualvairs-admin@corvair.org
[mailto:virtualvairs-admin@corvair.org] On Behalf Of Guus de Haan
Sent: Thursday, August 05, 2004 4:33 PM
To: Virtual Vairs
Subject: <VV> Installing viton o-rings

Just looking for conformation. You need to take off or lossen the heads
to change the o-rings on the push-rod tubes, right?

Regards,

Guus de Haan
'65 Corsa Cvt 180HP
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights
are the property of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to:
VirtualVairs@corvair.org List info:
http://www.vv.corvair.org/mailman/listinfo/virtualvairs
_______________________________________________