<VV> Installing viton o-rings

[Geoff Johnson]

You do, but you can do it two at a time by removing the rod guide for those 
two.  That way, remove one guide plate at a time, replace those two tubes 
rings then re-torque.  That way you should not lose torque on the head.


-Geoff


--On Thursday, August 05, 2004 10:33 PM +0200 Guus de Haan 
<guusdehaan@wanadoo.nl> wrote:

> Just looking for conformation. You need to take off or lossen the heads
> to change the o-rings on the push-rod tubes, right?
>
> Regards,
>
> Guus de Haan
> '65 Corsa Cvt 180HP
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights
> are the property of the writer, please attribute properly. For help,
> mailto:vv-help@corvair.org This list sponsored by the Corvair Society of
> America, http://www.corvair.org/ Post messages to:
> VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________