[V8Vairs] Hydraulic Clutch Question

[Tim Barrie]

Put the .625 clutch master on and it has made a very nice improvement. Still
a little heavy but not at all objectionable. I ended up with more travel
than I needed.
Thanks for everyone's input on this. Tim

-----Original Message-----
From: v8vairs-bounces at corvair.org [mailto:v8vairs-bounces at corvair.org] On
Behalf Of Tim Barrie
Sent: Monday, September 22, 2008 8:45 AM
To: 'discussion of non-stock engines in Corvairs'
Subject: Re: [V8Vairs] Hydraulic Clutch Question

Thanks everyone for their input. I will order the smaller diameter MC and
let you know how I make out. Tim 

-----Original Message-----
From: v8vairs-bounces at corvair.org [mailto:v8vairs-bounces at corvair.org] On
Behalf Of Jim Acker
Sent: Sunday, September 21, 2008 12:52 PM
To: v8vairs at corvair.org
Subject: [V8Vairs] Hydraulic Clutch Question

A couple points:
 
1.  The travel will be the same on the master, but the the slave travel will
decrease by approx. 36%
2.  The pedal resistance will be noticably lighter
3.  Lengthening the clutch arm will have no real effect on the pedal effort,
though it is a way to make up for the 36% loss in slave travel
 
Jim Acker
206.617.3550
 
_______________________________________________
V8Vairs mailing list
V8Vairs at corvair.org
http://www.vv.corvair.org/mailman/listinfo/v8vairs
This list sponsored by the Corvair Society of America,
http://www.corvair.org/

_______________________________________________
V8Vairs mailing list
V8Vairs at corvair.org
http://www.vv.corvair.org/mailman/listinfo/v8vairs
This list sponsored by the Corvair Society of America,
http://www.corvair.org/