[V8Vairs] Engine Side to Side Offset Measurement

[Chris Wills]

Rob,

It's right on.  !-1/4" is the correct measurement.  You are within a 1/16".  Close enough.

Chris Wills


  ----- Original Message ----- 
  From: WytchMedea at wmconnect.com<mailto:WytchMedea at wmconnect.com> 
  To: v8vairs at corvair.org<mailto:v8vairs at corvair.org> 
  Sent: Sunday, May 08, 2005 6:42 AM
  Subject: [V8Vairs] Engine Side to Side Offset Measurement


  When I picked up my car it was set up for a Buick V6 converted from a V8.  I 
  would like to put a V8 back in it but some of the previous adapting was a 
  little off center.  The best I can figure is that the engine sits an inch and 5/16 
  to the driver's side.  I am hoping that somebody here will be able to verify 
  this or set me straight.  Any help would be appreciated.

  Rob