[FC] A clutch failure

[J R Read]

Newly installed?  Has it slipped off of a pulley or has the routing under 
the truck changed from how you set it up?  Perhaps a clip that holds it in 
place has slipped?

Later, JR


----- Original Message ----- 
From: "Daniel Monasterio" <dmonasterio at hotmail.com>
To: <hallgrenn at aol.com>; "Ken Hand" <vairmech at aol.com>; "CORVANATICS" 
<corvanatics at corvair.org>; "Bob Gilbert" <corvairbob at bresnan.net>
Sent: Sunday, June 24, 2012 8:19 PM
Subject: Re: [FC] A clutch failure


>
> Don't think so as it still had the right end play after failure. It seemed 
> as the working pedal travel (floored) was not good enough to disengage. 
> BTW, the cable is an almost new GM with some 2,000 miles on it. Still 
> think on the diaphragm spring but, will use the truck on short trips only, 
> for further testings.
> Thanks
> Daniel
>
> From: HallGrenn at aol.com
> Date: Sun, 24 Jun 2012 21:08:00 -0400
> Subject: Re: [FC] A clutch failure
> To: dmonasterio at hotmail.com; vairmech at aol.com; corvanatics at corvair.org; 
> corvairbob at bresnan.net
>
>
>
>
>
>
>
> Daniel,
>
> If I read the symptoms correctly could you have a stretched cable?
>
>
> Bob
>
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/