[FC] unidentified holes
Lon Anderson
lonzovair at aol.com
Mon Aug 13 09:15:30 EDT 2012
Daniel is correct.
#1 & #3 are not on any of my Greenbriers either (2 '61s, a 62 & a 63)... the front hole is indeed the antenna hole (make sure you plug that hole, or else in cold weather you'll have a wee bit of a draft)... and the replacement rubber lid-holder for the battery is available from Lon and Cal... and maybe a few others.
Later,
Lonzo
-----Original Message-----
From: Steven R. Spilatro <spilatrs at marietta.edu>
To: Daniel Monasterio <dmonasterio at hotmail.com>; corvanatics <corvanatics at corvair.org>
Sent: Mon, Aug 13, 2012 9:06 am
Subject: Re: [FC] unidentified holes
Aha! so there's a way to hold the battery door open. I'll need to
look for that rubber latch. Holes 1 and 3 seem to be very cleanly
made (despite their appearance in the pictures) not like something
drilled by hand; but maybe... I was passing the antenna cable
through another hole like #2 but in the upper right hand side of the
removable panel; so the purpose of at least one of these holes remains unclear.
Thanks Daniel.
Steve
At 08:55 AM 8/13/2012, Daniel Monasterio wrote:
>No. 1 & 3 Are not present in my 62 Rampside nor in the 64 GB, they
>don't look factory made.
>No. 2 are in both 62 and 64. They have a holed rubber grommet where
>I pass the radio antenna cable thru but, not sure if it is the
>original purpose.
>No. 4 are for placing the bolts which hold the rubber latch to keep
>the battery cover door open.
>
>Daniel Monasterio
>
> > Date: Mon, 13 Aug 2012 08:20:23 -0400
> > To: corvanatics at corvair.org
> > From: spilatrs at marietta.edu
> > Subject: [FC] unidentified holes
> >
> > I'm looking for help identifying several holes in my '61 GB. You can
> > see pictures of them here:
> > http://www.marietta.edu/~spilatrs/Corvair/Unknown-holes.pdf
> > The holes are
> > 1) above the clutch pedal (about 1" dia)
> > 2) on the upper left side of large removable panel of front cowl
> (about 1" dia)
> > 3) to the right side of rear heater vent (about 1.5" dia)
> > 4) two threaded holes in left side rear inner panel
> >
> > Thanks for any help.
> > Steve
> >
> >
> >
> > _______________________________________________
> > Corvanatics mailing list
> > Corvanatics at corvair.org
> > http://www.vv.corvair.org/mailman/listinfo/corvanatics
> > This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
Dr. Steven R. Spilatro
Department of Biology and Environmental Science
Marietta College
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America, http://www.corvair.org/
More information about the Corvanatics
mailing list