[FC] muffler hanger replacement on Lakewood

[Andy]

Sorry about that first incomplete message.  The top bolt you are looking for is the bolt (or more likely stud) the the coil usually mounts to directly above the one you already took out - maybe 4 inches.  Get at it from the top through engine compartment.

Sent via MOTOBLUR™ on Verizon Wireless

-----Original message-----
From: Jim Forgey <jforgey4 at yahoo.com>
To: corvanatics <corvanatics at corvair.org>
Sent: Thu, Jun 30, 2011 01:34:29 GMT+00:00
Subject: [FC] muffler hanger replacement on Lakewood





Hi all,

non- FC question.

I am replacing the muffler hanger on my 61 Lakewood with the Clarks All in one 
part (complete metal and rubber hanger)

Went to take off what  is left of the old hanger (just the part bolted to the 
engine with a bit of the leather strap). Removed the bolt at the bottm right 
 (just below valve cover) and thought the piece would slide out  with some 
coaxing- before I start tapping (or swinging) with a hammer - is there a bolt 
somewhere that I can't see? I looked and felt around with no result.

Any help as always is welcome.

Jim Forgey
_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America, http://www.corvair.org/

_______________________________________________
Corvanatics mailing list
Corvanatics at corvair.org
http://www.vv.corvair.org/mailman/listinfo/corvanatics
This list sponsored by the Corvair Society of America, http://www.corvair.org/