[FC] Rampy speedo and stuff

[Ron]

What does your timing light show you???

RonH

----- Original Message ----- 
From: <wern3 at juno.com>
To: <corvanatics at corvair.org>
Sent: Saturday, April 04, 2009 9:39 PM
Subject: [FC] Rampy speedo and stuff


>I have a working speedo!! Turns out that I did not have the square end of 
>the cable deep enough into the tranny. I pulled out the end and the wire 
>was sorta twisted so I re - squared it using my dremel with drum grindstone 
>and threaded it back all the way;- Eureka!
> Windshield is intsalled after polishing out the worst of the scratches. 
> Many thans to the guys who suggested installing the gasket around the 
> glass first, then placing a 050 weed - whip cord in the groove. With two 
> neighbors I managed to get it set into place with a miniumum of fuss. That 
> is saying something as I once broke 2 windshields doing an install on a 
> LATE MOdel coupe. All the new guages work except the oil  temp.
> New problem. I have turned the distributor housing as far as it will go 
> Counter - clockwise, and it still runs rough, I suspect that I put the 
> distributor shaft into the hole and was 1 tooth off(?!?)
> poor idle. hesitation when throttle position changes and backfiring.
> Tim '61 Rampy .
> ____________________________________________________________
> Experience the wonder of a Costa Rican vacation. Click here for great 
> package deals!
> http://thirdpartyoffers.juno.com/TGL2141/fc/BLSrjpTHlJDLJ9IywZuYt3n53611cZ7DP5tO097c8jvqoLEPOqpOeABL0Ug/
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
>