[FC] FC exhaust

[J R Read_HML]

Check Figure 9-46 on Page 9-27 of the Shop Manual.

Later, JR

'61 Rampside Standard 4/110
'65 Monza Convertible 4/140
'66 beater Coupe - "icemobile" 4/140

----- Original Message ----- 
From: <Wild8bill at aol.com>
To: <corvanatics at corvair.org>
Sent: Thursday, August 03, 2006 10:45 PM
Subject: [FC] FC exhaust


>I got my new exhaust system from @%#!&$ today, and it almost fit! There 
>was
> only a stubborn 1/8" difference in the crossover pipe, nothing a 6' prybar
> couldn't take care of. Continuing with the project, I'm pondering the 
> stainless
> muffler strap that was included. I do not seem to have any place to loop 
> the
> "hook" around, and the included "special bolt" doesn't seem to go anywhere
> that  I can see. There are no exposed bolt holes that would lead me to 
> believe
> that  something is missing. The round muffler fits great in the cavity 
> under
> the body;  equidistant the whole way. Before I give up and fabricate my 
> own
> muffler hanger,  does anyone have a clue on where the included hanger 
> parts might
> go?  Thanks.
>
> Bill
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.394 / Virus Database: 268.10.5/406 - Release Date: 8/2/2006
>
>